If the error persists, use the Media size switches (SW2,3 - SW82,83 - SW92,93) test in the Tray/Bin
manual sensor test to test the switches. If they do not respond, replace associated the lifter drive
assembly.
Tray <X> overfilled
Description
The tray is filled above the stack-height mark.
◦
X = 2
Tray 2
◦
X = 3
Tray 3
◦
X = 4
Tray 4
◦
X = 5
Tray 5
◦
X = 6
Tray 6
Recommended action
Remove enough paper so that the paper stack does not exceed the limit for the tray.
NOTE: If this message appears after lifter drive assembly was removed or replaced, make sure that
the connector on the assembly is correctly connected and fully seated.
Troubleshooting
Description
The product is in the Troubleshooting process.
Recommended action
Press the Stop button
.
To exit press
Type mismatch Tray <X>
Description
The specified tray contains a paper type that does not match the configured type.
488 Chapter 3 Solve problems ENWW