Intermediate transfer belt (ITB)
CAUTION: Do not touch the black-plastic belt. Skin oils and fingerprints on the belt can cause print-
quality problems. Always place the ITB on a flat surface in a safe and protected location.
NOTE: If the ITB assembly is replaced, HP recommends that the secondary transfer roller be replaced
also. If both components are replaced at the same time, you must use the control-panel menus to reset
the Transfer Kit menu item. See
Reset the New Transfer Kit setting at the control panel
on page 104.
1. Open the right-door assembly.
2. Use both hands to grasp the blue levers (callout 1), apply slight downward pressure, and pull the
ITB toward you at a downward angle.
Figure 2-18 Remove the intermediate transfer belt (1 of 3)
1
102 Chapter 2 Removal and replacement ENWW