Filter
Top Products
Table 3-41 Embedded Jetdirect (continued)
First level Second level Third level Fourth level Fifth level Values Description
Dest IPv4 Range: 0 – 255
Default =
127.0.0.1
Type the IPv4 address.
Dest IPv6 Select from a
provided list.
Default = : : 1
Type the IPv6 address.
Packet Size Default = 64 Specify the size of each
packet, in bytes, to be sent to
the remote host. The minimum
is 64 (default) and the
maximum is 2048.
Timeout Default = 001 Specify the length of time, in
seconds, to wait for a response
from the remote host. The
default is 1 and the maximum
is 100.
Count Default = 004 Specify the number of ping test
packets to send for this test.
Select a value from 0 to 100.
The default is 4. To configure
the test to run continuously,
select 0.
Print Results Yes
No*
If the ping test was not set for
continuous operation, you can
choose to print the test results.
Select Yes to print results. If
you select No, results are not
printed.
Execute Yes
No*
Specify whether to initiate the
ping test. Select Yes to initiate
the test, or No to not run the
test.
Ping Results Packets Sent Default =
00000
Use this item to view the ping
test status and results using the
control panel display. You can
select the following items:
Shows the number of packets
(0 - 65535) sent to the remote
host since the most recent test
was initiated or completed. The
default is 0.
Packets
Received
Default =
00000
Shows the number of packets
(0 - 65535) received from the
remote host since the most
recent test was initiated or
completed. The default is 0.
398 Chapter 3 Solve problems ENWW