Install the main drive assembly
NOTE: Installing a replacement assembly: follow the instructions in this section.
Reinstalling the original assembly: some of these instructions in this section do not apply (for
example, removing the shipping spacers). Do not rotate the gears when handling the assembly. If the
gears are rotated—and become out of phase—it will be difficult to install the assembly on the product.
1. Do not remove the orange spacers and spacer shipping tape (callout 1) installed on the
replacement main drive assembly. Remove the remaining shipping tape (callout 2).
CAUTION: A gear (callout 3) on the back of the assembly is not captive when the shipping tape
is removed. Do not lose the gear when handling the assembly with the shipping tape removed.
When removing tape, make sure that the entire strip is removed. Check the back of the assembly
to verify that the entire strip of tape is removed.
Figure 2-102 Install the main drive assembly (1 of 8)
3
2
1
ENWW
Removal and replacement procedures
167