Filter
Top Products
Table 3-41 Embedded Jetdirect (continued)
First level Second level Third level Fourth level Fifth level Values Description
SNMP Test Yes
No*
This test checks operation of
SNMP communications by
accessing predefined SNMP
objects on the product.
Select Yes to choose this test,
or No to not choose it.
Data Path
Test
Yes
No*
This test helps to identify data
path and corruption problems
on an HP postscript level 3
emulation product. It sends a
predefined PS file to the
product, However, the test is
paperless; the file will not print.
Select Yes to choose this test,
or No to not choose it.
Select All
Tests
Yes
No*
Use this item to select all
available embedded tests.
Select Yes to choose all tests.
Select No to select individual
tests.
Execution
Time
Range: 1 – 60
hours
Default = 1
Use this item to specify the
length of time (in hours) that an
embedded test will be run. You
can select a value from 1 to 60
hours. If you select zero (1), the
test runs indefinitely until an
error occurs or the product is
turned off.
Data gathered from the HTTP,
SNMP, and Data Path tests is
printed after the tests have
completed.
Execute Yes
No*
No: Do not initiate the selected
tests.
Yes: Initiate the selected tests.
Ping Test Dest Type IPv4
IPv6
This test is used to check
network communications. This
test sends link-level packets to a
remote network host, then waits
for an appropriate response.
To run a ping test, set the
following items:
Specify whether the target
product is an IPv4 or IPv6
node.
ENWW
Tools for troubleshooting
397