Fuser motor (M4)
Before proceeding, remove the following components:
●
Toner collection unit. See
Toner-collection unit on page 91.
●
Right-front cover and control-panel assembly. See
Right-front cover and control-panel assembly
on page 113.
●
Left cover. See
Left cover on page 115.
●
Rear cover. See
Rear cover on page 116.
●
Toner collection unit access door. See
Toner collection unit access door on page 117.
●
Right-rear cover. See
Right-rear cover on page 119.
●
Top cover. See
Top cover on page 121.
●
Residual toner full sensor. See
Residual toner full sensor on page 152.
Remove the fuser motor
Disconnect one connector (callout 1), remove four screws (callout 2), and then remove the motor
(callout 3).
Figure 2-143 Remove the fuser motor
2
3
1
196 Chapter 2 Removal and replacement ENWW