Filter
Top Products
Network Settings menu
In the following table, asterisks (*) indicate the factory default setting.
Table 3-40 Network Settings menu
First level Values Description
I/O Timeout Range: 5 – 300 sec
Default = 15
Allows you to set the product I/O Timeout
in seconds. The default is 15 seconds.
Use this setting to adjust timeout for the best
performance. If data from other ports
appears in the middle of your print job,
increase the timeout value.
Embedded Jetdirect See the table that follows for details. These
menus have the same structure. If an
additional HP Jetdirect network card is
installed in the EIO slot, then both menus are
available.
Table 3-41 Embedded Jetdirect
First level Second level Third level Fourth level Fifth level Values Description
Information Print Sec
Report
Yes
No*
Yes: Prints a page that
contains the current security
settings on the HP Jetdirect
print server.
No: A security settings page is
not printed.
TCP/IP Enable On*
Off
On: Enable the TCP/IP
protocol.
Off: Disable the TCP/IP
protocol.
Host Name Use the arrow
buttons to edit
the host name.
NPIXXXXXX*
An alphanumeric string, up to
32 characters, used to identify
the product. This name is listed
on the HP Jetdirect
configuration page. The default
host name is NPIxxxxxx, where
xxxxxx is the last six digits of
the LAN hardware (MAC)
address.
ENWW
Tools for troubleshooting
391