Filter
Top Products
Model 5328A
General Information
1-8. APPLICATIONS
1-9. Specific applications information is provided in Section III of this manual. The general
application features of the 5328A are described in the following paragraphs.
1-10. The high sensitivity, frequency range, and signal conditioning controls (see Table 7-3)
make the 5328A suited for a wide range of applications.
1-11. The rear panel controlled “ARM” feature of the 5328A is useful in applications such as
burst frequency measurements, and pulse ampltiude measurements.
1-12. The 5328A single-shot resolution of 100 ns meets the requirements for applications
such as mechanical and electromechanical device (relays) timing, time of flight measurements
(ballistics), sonar ranging, radio ranging, and navigation.
1-13. Using time interval averaging, time intervals as short as 100 picosecond, with resolution
to 10 picosecond may be measured. Applications include coaxial cable length measurements,
phase measurements, logic timing measurements, and integrated circuit propagation delay
measurement.
1-14. Full bandwidth, sensitivity, and signal conditioning of the Channel A, B, and C input
amplifiers is provided for ratio and totalizing measurements.
1-15. The 5328A HP-IB Interface is able to output measurement data and be controlled (fully
programmed) via the Hewlett-Packard Interface Bus (HP-16). The 5328A may be interfaced
to HP-IB compatible instruments, calculators, or computers by interconnecting with an HP-IB
cable.
1-16. EQUIPMENT SUPPLIED AND ACCESSORIES AVAILABLE
1-17. Table 7-7 lists equipment supplied with the 5328A and Table 7-2 lists accessories avail-
able, The Service Kits listed in Table 1-2 are described in Section III.
Table 1-1. Equipment Supplied
DESCRIPTION
HP PART NUMBER
Detachable Power Cord 231 cm (7
1
/
2
ft.) long
8120-1348
Extender Board, 18 pin
05328-62016
Table 1-2. Accessories Available
DESCRIPTION HP PART NUMBER
HP Interface Bus Interconnect Cable 10631A, 914 mm (3 ft. long)
10631B, 1828 mm (6 ft. long)
10631C, 3656 mm (12 ft. long)
10631D, 0.5 m (1
1
/
2
ft. long)
Front Handle Kit
5061-0088
Rack Flange Kit (for instruments without handles)
5061-0076
Rack and Handle Kit (installation instructions included
5061-0082
with above kits)
Service Kit:
Function Selector and ROM Kit
05328-82004
1-18. SPECIFICATIONS
1-19. Table 1-3 lists detailed specifications for the 5328AF/096.
1-2