Filter
Top Products
Tray 1 Paper Pickup Roller & Separation Pad
Before you begin these steps, turn the
printer off and unplug the power cord.
1 Open Tray 1 by pulling down on the
top center of the front door.
2 Remove the envelope feeder access
cover by grasping each side of the tab
and pulling downward and toward
you.
3 To release the Pickup Roller pinch
the retaining clip on the right end of
the roller with your right hand while
sliding the roller to the right with
your left hand.
4 To remove the Pickup Roller push
in on the small plastic tab with your
right hand while sliding the roller off
the shaft with your left hand.
5 To remove the Separation Pad
insert a flat-blade screwdriver into the
indentation at the front of the pad.
Carefully rotate the screwdriver to
loosen the pad. When loose, gently
lift out the pad.
To install a new separation pad, place it
over the opening and press it down firmly
with your forefinger to seat it. Be sure the
metal edge is toward the front of the printer.
To install a new Pickup Roller, slide it
over the shaft and rotate it so that the flat
side of the roller is aligned with the flat
side of the shaft. Slide the roller to the
left until it clicks into place.
Reinstall the envelope feeder access cover
and discard the used roller and pad.
8-10 Maintaining and Adjusting the Printer EN