HP (Hewlett-Packard) HP LaserJet 5 Printer User Manual


 
Item Options Explanation
CLR WARN ON*
JOB
CLR WARN stands for “clearable warnings.” This setting determines how
long a clearable warning will be displayed on the printer control panel.
When set to ON, the warning is displayed until the [Go] key is pushed.
If set to JOB, the warning will be displayed until the end of the print job in
which it was generated.
AUTO CONT OFF*
ON
The auto continue function determines how the printer reacts to data and
printer errors. When auto continue is set to OFF, the printer displays an
error message and goes off line until you press [Go].
When auto continue is set to ON, the printer displays a message and goes
off line for about 10 seconds, then comes back on line.
If your printer is part of a network or remote spooling system, set auto
continue to ON.
TONER DENSITY 1
2
3*
4
5
Determines the relative darkness of print on the paper. To make print
darker, choose a higher number; to make it lighter, choose a lower
number. See “Fine-Tuning Print Quality” in Chapter 6.
TONER LOW CONT*
STOP
The TONER LOW message will first appear when the printer is almost out of
toner (about 100 to 300 sheets can still be printed).
If TONER LOW is set to CONT, the printer will remain on line and continue to
print while the message is displayed.
If TONER LOW is set to STOP, the printer will go off line and wait for further
action. See “Clearing the TONER LOW Message” in Chapter 8.
*Indicates factory default.
Table 3-8 Configuration Menu Items (continued)
3-12 Using the Printer Control Panel EN