Filter
Top Products
Caution
It is important to correctly align the right side panel and tighten the screw
on the back panel before attempting to move the printer.
Testing a SIMM Board
Use the procedures below to print a self test to verify SIMM board
installation. Procedures are given for both memory and PostScript
SIMMs.
Memory SIMM: running a self test printout
1 Plug in the power cord and switch the printer on.
2 After warm up, READY should appear in the control panel display. If
a printer message appears, see “Troubleshooting a SIMM Board” on
the following page.
3 Press [Menu] until TEST MENU appears in the display.
4 Press [Item] until PRINT SELF TEST appears in the display.
5 Press [Select] to print a self test.
6 Press [Go] to exit menus.
Locate “RAM SIZE” on the self-test printout (see “Understanding the
Self Test Printout” in Chapter 7 for more information). This is the
amount of memory now installed in your printer.
If the amount of memory has not increased since installing the SIMM, it
may not be installed correctly (repeat installation procedure) or the
SIMM may be defective (see “Troubleshooting a SIMM Board” on the
following page).
D
Printer Memory
EN Printer Memory D-9