Filter
Top Products
PostScript SIMM
Use these instructions to verify your PostScript SIMM installation:
1 Plug in the power cord and turn the printer on.
2 After warm up READY should appear in the control panel display. If a
printer message appears, see “Troubleshooting a SIMM Board” next
in this appendix.
3 Press [Menu] until PS MENU appears in the display. If this message
appears, your printer recognizes that the PostScript language is installed.
If PS MENU does not appear, check the SIMM installation.
4 Press [Go] to exit menus.
Troubleshooting a SIMM Board
Service / Error Messages
These messages can be generated when your printer is checking its
internal memory. (For more information on the messages below, see
Chapter 7, “Solving Printer Problems.”)
Error Problem
Solution
62.x ERROR
where x = 0, 1,
2, 3, or 4.
This error indicates your printer identified a
problem while checking memory.
If x = 0, the problem is in internal Read Only
Memory (ROM). If x = 1, 2, 3, or 4, the problem
is in SIMM slot 1, 2, 3, or 4. See the checking
procedure for 62.x ERROR described on the
next page.
63 NEEDS SERVICE The printer found a problem in its internal RAM
memory.
Switch your printer OFF, then ON, to clear the
error. If the message reappears, call your
authorized HP dealer or service representative.
D-10 Printer Memory EN