Filter
Top Products
Loading Envelopes in the Envelope Feeder
Note
Only print on approved envelopes. See
“Printing Envelopes” earlier in this
chapter and “Envelopes” in Appendix A.
1
Lift up the pressure plate (A). It will
stay in a vertical position. Pull the
extension tray out (B).
2 Squeeze the release lever against the
envelope side guide (A) and slide the
side guide all the way to the right (B).
3 Load envelopes into the Envelope
Feeder with the print-side up, the
sealing flap down, and the postage
end in.
Note
Do not fill the Envelope Feeder above the
arrow on the envelope side guide. Make
sure envelope flaps are not interlocked or
stuck together.
4 Lower the pressure plate against the
envelope stack.
5 Slide the envelope side guide against
the envelope stack. The guide should
be pressed firmly against the stack,
but not tight enough to buckle the
envelopes.
Note
Make sure the envelopes are pushed into
the Envelope Feeder as far as they can go.
4
Printing
EN Printing 4-29