Filter
Top Products
Fusing Assembly
Before you begin these steps, turn the
printer off and unplug the power cord.
WARNING!
The fusing area gets hot! After
unplugging the power cord, allow the
printer to cool for at least 30 minutes
before continuing.
1 After the printer is cool, open the rear
cover.
2 Remove the 2 screws that hold the
fusing assembly to the printer.
3 See the Caution below, then gently
lift the fusing assembly up and pull it
straight out from the printer body.
Caution
Pull the fusing assembly straight out from
the printer. Otherwise the sensor lever,
located on the right rear of the fusing
assembly, may catch on the inside of the
printer.
4 Slide the new fusing assembly firmly
into the printer until the screw holes
align, then replace the screws,
tightening until snug.
Note
If the message 50 FUSER ERROR, CYCLE
POWER appears in the display, switch the
printer off and wait 15 minutes. If the
problem continues, check the fuser
installation again. If the problem still
continues, contact your authorized HP dealer.
8
Maintaining and
Adjusting the
8
Maintaining and
Adjusting the
EN Maintaining and Adjusting the Printer 8-13