Filter
Top Products
6 Loosen the captive screw holding the
SIMM door with a Phillips #2
screwdriver. Open the SIMM door.
7 Note the four SIMM slots (a PostScript
SIMM will already be installed in a slot
in the HP LaserJet 5M). For easiest
installation, fill the slots from right to
left, starting with slot 1 (see inset).
8 Remove the SIMM board from the
antistatic package. Hold the board with
your forefingers on the side edges and
your thumbs against the back edge.
Hold the board so the notch on one end
is on the bottom and the metal teeth
face toward the SIMM slot.
9 Hold the SIMM board at a 30-degree
angle to the slot and push the edge of
the board evenly and firmly into the
slot (see A). Rotate the SIMM board
to the right until the board “clicks”
into the metal locking tabs, securing
the board in place (see B).
Close the SIMM door and tighten the
screw (see picture 6).
Set the bottom of the right side panel onto the
printer. Make sure the three bottom tabs on
the panel align with the corresponding slots
on the printer. Fold the cover up. The printer
is now in the same condition as picture 4.
10 Slide the panel to the left until it
becomes firm (1/4 inch gap (7 mm)
remaining). Tighten the screw in the
upper left corner on the back panel.
This will close the remaining gap
between the panel and the frame.
Continued on the next page
D-8 Printer Memory EN