NEC NP-PH1202HL Projector User Manual


  Open as PDF
of 198
 
ix
Important Information
Clearance for Installing the Projector
Allowampleclearancebetweentheprojectoranditssurroundingsasshownbelow.
Thehightemperatureexhaustcomingoutofthedevicemaybesuckedintothedeviceagain.
AvoidinstallingtheprojectorinaplacewhereairmovementfromtheHVACisdirectedattheprojector.
HeatedairfromtheHVACcanbetakeninbytheprojector'sintakevent.Ifthishappens,thetemperatureinsidethe
projectorwillrisetoohighcausingtheover-temperatureprotectortoautomaticallyturnofftheprojectorspower.
• Beforesettingtheprojectorinportraitorientation,pleasereadpage140,Portraitprojection(verticalorientation).
Example 1 – If there are walls on both sides of the projector.
30cm/11.8"orgreater 30cm/11.8"orgreater
IntakeventIntakevent
NOTE:
The drawing shows the proper clearance required for the front, back, and top of the projector.
Example 2 – If there is a wall behind the projector.
(1) For floor installation:
70cm/27.6"orgreater
Lens
Exhaustvent
NOTE:
The drawing shows the proper clearance required for the back, right, left, and top of the projector.
(2) For ceiling mounting:
30cm/12"orgreater
70cm/27.6"orgreater
Lens
NOTE:
1. The drawing shows the proper clearance required for the front, right, left, back, and bottom of the projector.
2. If suspending the projector within the range of 30 cm/12 inches away from the ceiling, allow ample clearance for all four sides
and the under the projector.
 previous next