NEC NP-PH1202HL Projector User Manual


  Open as PDF
of 198
 
15
2. Projecting an Image (Basic Operation)
❸ Turning on the Projector
NOTE:
• Theprojectorhastwopowerswitches:AmainpowerswitchandaPOWERbutton(POWERONandOFFontheremotecontrol)
•Turningontheprojector:
1. Press the main power switch to the ON position (I).
 Theprojectorwillgointostandbymode.
2. Press the POWER button .
 Theprojectorwillbecomereadytouse.
•Turningofftheprojector:
1. Press the POWER button.
 Theconrmationmessagewillbedisplayed.
2. Press the POWER button again.
 Theprojectorwillgointostandbymode.
3. Press the main power switch to the OFF position (O).
 Theprojectorwillbeturnedoff.
1. Press the main power switch to the ON position ( I ).
 ThePOWERindicatorlightsupred.*
* ThisindicatesthattheSTANDBYmodeisin[NORMAL]
setting.
(→
page122,175)
• Thebuzzersoundisreleasedwhen[NOTIFICATION
SETTING]for[BUZZER]isON.
WARNING
Theprojector producesa stronglight.When turningon
thepower,makesurenoonewithinprojectionrangeis
lookingatthelens.
NOTE:
• The[STANDBYMODE]settingwillbedisabledandtheprojector
will go into the sleep mode when the network service is utilized
ortheprojectorreceivesHDBaseTsignal.Inthesleepmode,the
fans in the projector sometimes rotate for the purpose of interior
partsprotection.Pleaserefertopage122 about the sleep mode.
 previous next