NEC NP-PH1202HL Projector User Manual


  Open as PDF
of 198
 
16
2. Projecting an Image (Basic Operation)
2. Press the (POWER) button on the projector cabinet
or the POWER ON button on the remote control.
 ThePOWERindicator goesfroma steadyredlight to
aashingbluelight,andthepictureisprojectedonthe
screen.
• Ifusingtheremotecontrol,pressthePOWERONbutton.
• Whenthereisnosignaltheunitwillprojectabluescreen
(factorydefaultmenusettings).
• Ifthepictureisblurry,adjustthescreenfocus.(→page
24)
• Whenitisdarkpressthe (lights)button.Theindicator
panelbacklightandtheLEDlampontherightsideof
theprojectorwillturnon.(→page7)
TIP:
• TheunithasaPowerOnShutterfunctionthatallowsthelight
sourcetoturnoffevenwhenconnectedtoapowersource.(→
page 105)
• PressingthebuttonwillnotactivatetheunitwhentheKEYLOCK
indicatorisflashingorange.(→ page 28)
• Whenthemessage“PROJECTORISLOCKED!ENTERYOUR
PASSWORD.”isdisplayed,itmeansthat the[SECURITY]
featureisturnedon.(→ page 38)
 Afteryouturnonyourprojector,ensurethatthecomputer
orvideosourceisturnedon.
NOTE:Thebluescreen([BLUE]background)isdisplayedwhenno
signalisbeinginput(byfactorydefaultmenusettings).
Standby Blinking Power On
Steady red light Blinking blue
light
Steady blue
light
(→page175)
Performing Lens Calibration
• Afterinstallingor replacingthe lensunit (below*) sold
separately,presstheLENSCALIBRATIONbuttononthe
projector,orholddowntheCTLbuttonontheremotecontrol
thenpresstheINFO/L-CALIB.buttontocarryout[LENS
CALIBRATION].
Bycarryingout [LENSCALIBRATION], theadjustment
rangeofthezoomandfocusofthe[LENSMEMORY]is
calibrated.
 Ifyouneedtoinstallorreplacethelensunit,contactyour
dealerandhavethemdoitforyou.
 previous next