Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Switching Commands 8-43
202-10088-01, March 2005
Format speed all {<100 | 10> <half-duplex | full-duplex>}
Mode Global Config
Acceptable values are:
100h 100BASE-T half-duplex
100f 100BASE-T full duplex
10h 10BASE-T half duplex
10f 10BASE-T full duplex
storm-control broadcast
This command enables broadcast storm recovery mode. If the mode is enabled, broadcast storm
recovery with high and low thresholds is implemented.
The threshold implementation follows a percentage pattern. If the broadcast traffic on any Ethernet
port exceeds the high threshold percentage (as represented in Table 1) of the link speed, the switch
discards the broadcasts traffic until the broadcast traffic returns to the low threshold percentage or
less. The full implementation is depicted in the Table 1.
Format
storm-control broadcast
Mode Global Config
no storm-control broadcast
This command disables broadcast storm recovery mode.
The threshold implementation follows a percentage pattern. If the broadcast traffic on any Ethernet
port exceeds the high threshold percentage (as represented in Table 2) of the link speed, the switch
discards the broadcasts traffic until the broadcast traffic returns to the low threshold percentage or
less. The full implementation is depicted in the Table 2.
Table 1. Broadcast Storm Recovery Thresholds
Link Speed High Low
10M 20 10
100M 5 2
1000M 5 2