Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
8-126 Switching Commands
202-10088-01, March 2005
spanning-tree port mode all
This command sets the Administrative Switch Port State for all ports to enabled.
Default disabled
Format spanning-tree port mode all
Mode Global Config
no spanning-tree port mode all
This command sets the Administrative Switch Port State for all ports to disabled.
Format no spanning-tree port mode all
Mode Global Config
spanning-tree
This command sets the STP mode for a specific port-channel (LAG). This is the value specified
for STP Mode on the Port Configuration Menu. 802.1D mode is the default. The interface is a
logical slot/port for a configured port-channel. The
all option sets all configured port-channels
(LAGs) with the same option.
Format
spanning-tree {<logical slot/port> | all | <off |
802.1d | fast>}
Mode Global Config
The mode is one of the following:
802.1d IEEE 802.1D-compliant STP mode is used
fast Fast STP mode is used
off STP is turned off
spanning-tree bpdumigrationcheck
This command enables BPDU migration check on a given interface. The all option enables BPDU
migration check on all interfaces.
Format
spanning-tree bpdumigrationcheck {<slot/port> | all}
Mode Global Config