Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Quality of Service (QoS) Commands 11-23
202-10088-01, March 2005
Note: The actual bandwidth allocation does not occur until the policy is attached to an interface in
a particular direction.
Note: The expedite kbps and percent commands are alternative ways to specify the same expedite
policy attribute.
Format
expedite percent <1-100> [1-128]
Mode Policy-classmap Config
Restrictions The sum of the committed information rate values for all band-
width and expedite commands defined within a policy must not
exceed the available link bandwidth of the interface to which that
policy is assigned. Violation of this requirement shall prevent
successful attachment of a policy to the interface, or shall cause
this command to fail if the policy is already in service on one or
more interfaces.
Policy Type Out
Incompatibilities Bandwidth (all forms), Shape Peak
mark cos
This command marks all packets for the associated traffic stream with the specified class of
service value in the priority field of the 802.1p header. If the packet does not already contain this
header, one is inserted. The CoS value is an integer from 0 to 7.
Default 1
Format
mark-cos <0-7>
Mode Policy-classmap Config
Policy Type In
mark ip-dscp
This command marks all packets for the associated traffic stream with the specified IP DSCP
value.
The <dscpval> value is specified as either an integer from 0 to 63, or symbolically through one of
the following keywords:
af11, af12, af13, af21, af22, af23, af31, af32, af33, af41,
af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef.
Format mark ip-dscp <dscpval>
Mode Policy-classmap Config