Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
8-98 Switching Commands
202-10088-01, March 2005
Mode Interface Config
set garp timer leave all
This command sets the GVRP leave time for all ports. Leave time is the time to wait after
receiving an unregister request for a VLAN or a multicast group before deleting the VLAN entry.
This can be considered a buffer time for another station to assert registration for the same attribute
in order to maintain uninterrupted service.time is 20 to 600 (centiseconds). The value 60
centiseconds is 0.6 seconds.
Note: This command has an effect only when GVRP is enabled.
Default 60
Format
set garp timer leave all <20-600>
Mode Global Config
no set garp timer leave all
This command sets the GVRP leave time for all ports to the default 60 centiseconds (0.6 seconds).
Note: This command has an effect only when GVRP is enabled.
Format no set garp timer leave all
Mode Global Config
set garp timer leaveall
This command sets how frequently Leave All PDUs are generated per port. A Leave All PDU
indicates that all registrations will be unregistered. Participants would need to rejoin in order to
maintain registration. The value applies per port and per GARP participation. The time may range
from 200 to 6000 (centiseconds). The value 1000 centiseconds is 10 seconds.
Note: This command has an effect only when GVRP is enabled.
Default 1000
Format
set garp timer leaveall <200-6000>
Mode Interface Config
no set garp timer leaveall
This command sets how frequently Leave All PDUs are generated per port to 1000 centiseconds (10
seconds). .