Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Quality of Service (QoS) Commands 11-21
202-10088-01, March 2005
Incompatibilities Expedite (all forms)
bandwidth percent
This command identifies a minimum amount of bandwidth to be reserved for the specified class
instance within the named policy using a relative rate notation. The committed information rate is
specified as a percentage of total link capacity and is an integer from 1 to 100.
Note: The actual bandwidth allocation does not occur until the policy is attached to an interface in
a particular direction.
Note: The bandwidth kbps and percent commands are alternative ways to specify the same
bandwidth policy attribute.
Format
bandwidth percent <1-100>
Mode Policy-classmap Config
Restrictions The sum of the committed information rate values for all band-
width and expedite commands defined within a policy must not
exceed the available link bandwidth of the interface to which that
policy is assigned. Violation of this requirement shall prevent
successful attachment of a policy to the interface, or shall cause
this command to fail if the policy is already in service on one or
more interfaces.
Policy Type Out
Incompatibilities Expedite (all forms)
class
This command creates an instance of a class definition within the specified policy for the purpose
of defining treatment of the traffic class through subsequent policy attribute statements. The
<
classname> is the name of an existing DiffServ class. Note that this command causes the
specified policy to create a reference to the class definition.
Note: The CLI mode is changed to Policy-classmap Config when this command is successfully
executed.
Format
class <classname>
Mode Policy-Map Config