Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Switching Commands 8-73
202-10088-01, March 2005
sntp client mode
This command will disable Simple Network Time Protocol (SNTP) client mode.
Format
no sntp client mode
Mode Global Config
sntp client port
This command will set the SNTP client port id to a value from 1-65535.
Default
123
Format sntp client port <portid>
Mode Global Config
no sntp client port
This command will reset the SNTP client port back to its default value.
Format
no sntp client port
Mode Global Config
sntp unicast client poll-interval
This command will set the poll interval for SNTP unicast clients in seconds as a power of two
where <poll-interval> can be a value from 6 to 16.
Default
6
Format sntp unicast client poll-interval <poll-interval>
Mode Global Config
no sntp unicast client poll-interval
This command will reset the poll interval for SNTP unicast clients to its default value.
Format
no sntp unicast client poll-interval
Mode Global Config