Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Switching Commands 8-107
202-10088-01, March 2005
Format no set igmp groupmembership-interval
Mode Global Config
set igmp interfacemode all
This command enables IGMP Snooping on all interfaces. If an interface which has IGMP
Snooping enabled is enabled for routing or is enlisted as a member of a port-channel (LAG),
IGMP Snooping functionality will be disabled on that interface. IGMP Snooping functionality will
subsequently be re-enabled if routing is disabled or port-channel (LAG) membership is removed
from an interface that has IGMP Snooping enabled.
Default disabled
Format
set igmp interfacemode all
Mode Global Config
no set igmp interfacemode all
This command disables IGMP Snooping on all interfaces.
Format
no set igmp interfacemode all
Mode Global Config
set igmp maxresponse
This command sets the IGMP Maximum Response time on the system. The Maximum Response
time is the amount of time in seconds that a switch will wait after sending a query on an interface
because it did not receive a report for a particular group in that interface. This value must be less
than the IGMP Query Interval time value. The range is 1 to 3599 seconds.
Default 10
Format
set igmp maxresponse <1-3599>
Mode Global Config
no set igmp maxresponse
This command sets the IGMP Maximum Response time on the system to 10 seconds.
Format
no set igmp maxresponse
Mode Global Config