Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Routing Commands 10-25
202-10088-01, March 2005
distribute-list out
This command is used to specify the access list to filter routes received from the source protocol.
Default
0
Format distribute-list <1-199> out {bgp | static | connected}
Mode Router RIP Config
no distribute-list out
This command is used to specify the access list to filter routes received from the source protocol.
Format
no distribute-list <1-199> out {bgp | static | con-
nected}
Mode Router RIP Config
no default-information originate
This command is used to control the advertisement of default routes.
Format
no default-information originate
Mode Router RIP Config
ip rip authentication
This command sets the RIP Version 2 Authentication Type and Key for the specified interface. The
value of <type> is either none, simple, or encrypt.
The value for authentication key [key] must be 16 bytes or less. The [key] is composed of standard
displayable, non-control keystrokes from a Standard 101/102-key keyboard. If the value of <type>
is encrypt, a keyid in the range of 0 and 255 must be specified.
Default
The default authentication type is none.
Default The default password key is an empty string. Unauthenticated interfaces do not
need an authentication key.
Default The default key id is not defined. Unauthenticated interfaces do not need an
authentication key id.
Format ip rip authentication {none | {simple <key>} |
{encrypt <key> <keyid>}}
Mode Interface Config