Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Switching Commands 8-47
202-10088-01, March 2005
Format show port {<slot/port> | all}
Mode Privileged EXEC
Slot/Port Valid slot and port number separated by forward slashes.
Type If not blank, this field indicates that this port is a special type of
port. The possible values are:
Mon - this port is a monitoring port. Look at the Port Monitoring
screens to find out more information.
Lag - this port is a member of a port-channel (LAG).
Probe - this port is a probe port.
Admin Mode Selects the Port control administration state. The port must be
enabled in order for it to be allowed into the network. - May be
enabled or disabled. The factory default is enabled.
Physical Mode Selects the desired port speed and duplex mode. If auto-negotia-
tion support is selected, then the duplex mode and speed will be
set from the auto-negotiation process. Note that the port's maxi-
mum capability (full duplex -100M) will be advertised. Other-
wise, this object will determine the port's duplex mode and
transmission rate. The factory default is Auto.
Physical Status Indicates the port speed and duplex mode.
Link Status Indicates whether the Link is up or down.
Link Trap This object determines whether or not to send a trap when link
status changes. The factory default is enabled.
LACP Mode
Displays whether LACP is enabled or disabled on this port.
show port protocol
This command displays the Protocol-Based VLAN information for either the entire system, or for
the indicated Group.
Format
show port protocol <groupid | all>
Mode Privileged EXEC
Group Name This field displays the group name of an entry in the Protocol-based VLAN
table.
Group ID This field displays the group identifier of the protocol group.
Protocol(s) This field indicates the type of protocol(s) for this group.