Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
11-24 Quality of Service (QoS) Commands
202-10088-01, March 2005
Policy Type In
Incompatibilities Mark IP Precedence, Police (all forms)
mark ip-precedence
This command marks all packets for the associated traffic stream with the specified IP Precedence
value. The IP Precedence value is an integer from 0 to 7.
Format
mark ip-precedence <0-7>
Mode Policy-classmap Config
Policy Type In
Incompatibilities Mark IP DSCP, Police (all forms)
police-simple
This command is used to establish the traffic policing style for the specified class. The simple form
of the police command uses a single data rate and burst size, resulting in two outcomes: conform
and nonconform. The conforming data rate is specified in kilobits-per-second (Kbps) and is an
integer from 1 to 4294967295. The conforming burst size is specified in kilobytes (KB) and is an
integer from 1 to 128.
For each outcome, the only possible actions are drop, set-cos-transmit,| set-sec-cos-transmit, set-
dscp-transmit, set-prec-transmit, or transmit. In this simple form of the police command, the
conform action defaults to transmit and the violate action defaults to drop. These actions can be set
with this command once the style has been configured.
For set-dscp-transmit, a <
dscpval> value is required and is specified as either an integer from 0 to
63, or symbolically through one of the following keywords:
af11, af12, af13, af21, af22, af23, af31, af32,
af33, af41, af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef
.
For set-prec-transmit, an IP Precedence value is required and is specified as an integer from 0-7.
Format
police-simple {<1-4294967295> <1-128> conform-action
{drop | set-cos-transmit <0-7> | set-sec-cos-transmit
<0-7> | set-prec-transmit <0-7> | set-dscp-transmit
<0-63> | transmit} [violate-action {drop | set-cos-
transmit <0-7> | set-sec-cos-transmit <0-7> | set-
prec-transmit <0-7> | set-dscp-transmit <0-63> |
transmit}]}
Mode Policy-classmap Config