Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
11-20 Quality of Service (QoS) Commands
202-10088-01, March 2005
redirect
This command specifies that all incoming packets for the associated traffic stream are redirected to
a specific egress interface (physical port or port-channel).
Format redirect <slot/port>
Mode
Policy-Class-Map Config
conform-color
This command is used to enable color-aware traffic policing and define the conform-color and
exceed-color class maps used. Used in conjunction with the police command where the fields for
the conform level (for simple, single-rate, and two-rate policing) and optionally the exceed level
(for single-rate and two-rate policing) are specified. The <
class-map-name> parameter is the
name of an existing Diffserv class map, where different ones must be used for the conform and
exceed colors.
Format
conform-color <class-map-name> [exceed-color <class-
map-name>]
Mode Policy-Class-Map Config
bandwidth kbps
This command identifies a minimum amount of bandwidth to be reserved for the specified class
instance within the named policy using an absolute rate notation. The committed information rate
is specified in kilobits-per-second (Kbps) and is an integer from 1 to 4294967295.
Note: The actual bandwidth allocation does not occur until the policy is attached to an interface in
a particular direction.
Note: The bandwidth kbps and percent commands are alternative ways to specify the same
bandwidth policy attribute.
Format
bandwidth kbps <1-4294967295>
Mode Policy-classmap Config
Restrictions The sum of the committed information rate values for all band-
width and expedite commands defined within a policy must not
exceed the available link bandwidth of the interface to which that
policy is assigned. Violation of this requirement shall prevent
successful attachment of a policy to the interface, or shall cause
this command to fail if the policy is already in service on one or
more interfaces.
Policy Type Out