Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
8-72 Switching Commands
202-10088-01, March 2005
Host Status The state of logging to configured syslog hosts. If the status is
disable, no logging occurs.
Simple Network Time Protocol (SNTP)
This section provides a detailed explanation of the SNTP commands. The commands are divided
into two functional groups:
• Show commands display spanning tree settings, statistics, and other information.
• Configuration Commands configure features and options of the switch. For every
configuration command there is a show command that displays the configuration setting.
sntp broadcast client poll-interval
This command will set the poll interval for SNTP broadcast clients in seconds as a power of two
where <poll-interval> can be a value from 6 to 16.
Default
6
Format sntp broadcast client poll-interval <poll-interval>
Mode Global Config
no sntp broadcast client poll-interval
This command will reset the poll interval for SNTP broadcast client back to its default value.
Format
no sntp broadcast client poll-interval
Mode Global Config
sntp client mode
This command will enable Simple Network Time Protocol (SNTP) client mode and optionally
setting the mode to either broadcast, multicast, or unicast.
Default
Disabled
Format sntp client mode [broadcast | multicast | unicast]
Mode Global Config