Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
11-30 Quality of Service (QoS) Commands
202-10088-01, March 2005
Note: This command shall fail if any attributes within the policy definition exceed the capabilities
of the interface. Once a policy is successfully attached to an interface, any attempt to change the
policy definition such that it would result in a violation of said interface capabilities shall cause the
policy change attempt to fail.
Format
service-policy <in | out> <policymapname>
Modes Global Config (for all system interfaces)
Interface Config (for a specific interface)
Restrictions Only a single policy may be attached to a particular interface in a
particular direction at any one time.
no service-policy
This command detaches a policy from an interface in a particular direction. The command can be
used in the Interface Config mode to detach a policy from a specific interface. Alternatively, the
command can be used in the Global Config mode to detach this policy from all system interfaces
to which it is currently attached. The direction value is either in or out. The <
policyname>
parameter is the name of an existing DiffServ policy. Note that this command causes a service to
remove its reference to the policy.
Note: This command effectively disables DiffServ on an interface (in a particular direction).
There is no separate interface administrative 'mode' command for DiffServ.
Format
no service-policy <in | out> <policymapname>
Modes Global Config (for all system interfaces)
Interface Config (for a specific interface)
Show Commands
The 'show' command set is used in DiffServ to display configuration and status information for:
• Classes
• Policies
•Services
This information can be displayed in either summary or detailed formats. The status information is
only shown when the DiffServ administrative mode is enabled; it is suppressed otherwise.
There is also a 'show' command for general DiffServ information that is available at any time.