Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Routing Commands 10-9
202-10088-01, March 2005
Format ip route default <nextHopRtr> [<preference>]
Mode Global Config
no ip route default
This command deletes all configured default routes. If the optional <nextHopRtr> parameter is
designated, the specific next hop is deleted from the configured default route and if the optional
preference value is designated, the preference of the configured default route is reset to its default.
Format
no ip route default [{<nextHopRtr> | <preference>}]
Mode Global Config
ip route distance
This command sets the default distance for static routes. Lower route preference values are
preferred when determining the best route. The "ip route" and "ip route default" commands allow
you to optionally set the distance of an individual static route. The default distance is used when no
distance is specified in these commands. Changing the default distance does not update the
distance of existing static routes, even if they were assigned the original default distance. The new
default distance will only be applied to static routes created after invoking the "ip route distance"
command.
Default
1
Format ip route distance <1-255>
Mode Global Config
no ip route distance
This command sets the default static route preference value in the router. Lower route preference
values are preferred when determining the best route.
Format
no ip route distance
Mode Global Config
ip forwarding
This command enables forwarding of IP frames.
Default
enabled