Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Quality of Service (QoS) Commands 11-45
202-10088-01, March 2005
tail-drop queue-parms <queue-id-1> [<queue-id-2> … <queue-id-n>] threshold <0-16> <0-16>
<0-16>
no tail-drop queue-parms <queue-id-1> [<queue-id-2> … <queue-id-n>]
Modes Global Config
Interface Config
traffic-shape
This command specifies the maximum transmission bandwidth limit for the interface as a whole.
Also known as rate shaping, this has the effect of smoothing temporary traffic bursts over time so
that the transmitted traffic rate is bounded. Use the 'no' form of this command to restore the
default interface shaping rate value.
traffic-shape <bw>
no traffic-shape
Modes Global Config
Interface Config
show classofservice dot1p-mapping
This command displays the current Dot1p (802.1p) priority mapping to internal traffic classes for a
specific interface. The slot/port parameter is optional and is only valid on platforms that support
independent per-port class of service mappings. If specified, the 802.1p mapping table of the
interface is displayed. If omitted, the most recent global configuration settings are displayed.
Format show classofservice dot1p-mapping [slot/port]
Mode Privileged EXEC
The following information is repeated for each user priority.
User Priority The 802.1p user priority value.
Traffic Class The traffic class internal queue identifier to which the user prior-
ity value is mapped.