Filter
Top Products
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Quality of Service (QoS) Commands 11-25
202-10088-01, March 2005
Restrictions Only one style of police command (simple, singlerate, tworate) is
allowed for a given class instance in a particular policy.
Policy Type In
Incompatibilities Mark IP DSCP, Mark IP Precedence
police-single-rate
This command is used to establish the traffic policing style for the specified class. The single-rate
form of the police command uses a single data rate and two burst sizes, resulting in three
outcomes: conform, exceed and violate. The conforming data rate is specified in kilobits-per-
second (Kbps) and is an integer from 1 to 4294967295. The conforming burst size is specified in
kilobytes (KB) as an integer from 1 to 128. The exceeding burst size is specified in kilobytes (KB)
as an integer from 1 to 128. Note that the exceeding burst size must be equal to or greater than the
conforming burst size.
For each outcome, the only possible actions are drop, set-cos-transmit, set-sec-cos-transmit, set-
dscp-transmit, set-prec-transmit, or transmit. In this singlerate form of the police command, the
conform action defaults to send, the exceed action defaults to drop, and the violate action defaults
to drop. These actions can be set with this command once the style has been configured.
For set-dscp-transmit, a <
dscpval> value is required and is specified as either an integer from 0 to
63, or symbolically through one of the following keywords:
af11, af12, af13, af21, af22, af23, af31, af32,
af33, af41, af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef
.
For set-prec-transmit, an IP Precedence value is required and is specified as an integer from 0-7.
Format
police-single-rate {<1-4294967295> <1-128> <1-128>
conform-action {drop | set-cos-transmit <0-7> | set-
sec-cos-transmit <0-7> | set-prec-transmit <0-7> |
set-dscp-transmit <0-63> | transmit} exceed-action
{drop | set-cos-transmit <0-7> | set-sec-cos-transmit
<0-7> | set-prec-transmit <0-7> | set-dscp-transmit
<0-63> | transmit} [violate-action {drop | set-cos-
transmit <0-7> | set-sec-cos-transmit <0-7> | set-
prec-transmit <0-7> | set-dscp-transmit <0-63> |
transmit}]}
Mode Policy-classmap Config
Restrictions Only one style of police command (simple, singlerate, tworate) is
allowed for a given class instance in a particular policy.
Policy Type In
Incompatibilities Mark IP DSCP, Mark IP Precedence