Filter
Top Products
Category LCD status message Trouble or status Remedy
40930701TH DRAFT Vesion
124 /
Daily status Replace the toner cartridge.
Check the operation of the toner sensor lever.
Replace the Power Supply Unit (High Voltage)
Replace the main board.
Note: When replacing the main board, install the EEPROM
mounted on the replaced main board.
Repace the image drum cartridge.
Note: After replacing the drum cartridge, reset the drum
counter. (Refer to the User's Manual)
Replace the fuser unit.
Note: After replacing the fuser unit reset the fuser counter.
(Refer to chapter 4.2.1)
Normal operation.
Normal operation
Informs that the amount of toner low
This is indicated in combination with other messages of the first line.
Normal operation is possible.
But when "LOW TONER= OFF" has been selected in the menu,
ATTENTION LED will flash.
Informs that toner sensor detects an error.
But when the total drum count were > 30 pages, this error would be
indicated, when the total drum count were= < 30 pages, an impossible-
to reset alarm "ERROR 77" , which will be described later, would be
indicated.
This is indicated in combination with other messages of the first line.
Normal operation is passible.
Informs of the drum life.
This is indicated in combination with other messages of the first line.
Normal operation is enabled if desired.
Informs that the life of a replaceable part such as fuser (fusing device)
and roller.
This is indicated in combination with other messages of the first line.
Normal operation is possible.
Indicates that the number of sheets in current printing when the number
of copies is two or more.
Deletes not-yet-printed data within the buffer and initiates the status of
the printer to user default.
Temporary DLL/ macro/ user pattern will be deleted.
TONER SENSOR
TONER LOW
COPY nnn/mmm
FUSER LIFE
CHANGE DRUM
RESET
READY
ATTENTION
or
READY
ATTENTION
READY
ATTENTION
READY
ATTENTION
READY
or
ATTENTION
READY
ATTENTION