Filter
Top Products
Category LCD READY ATTENTION Trouble or status Remedy
message LED LED
40930701TH DRAFT Vesion
130 /
A fault occurred in the printer.
Turn the power off, then on to release the error display. If the error
display cannot be released by this procedure, call a service person.
Code Error
(nn)
10 An error was detected by program hash check.
20 An error was detected by font format check.
30 An error was detected by resident RAM check.
40 An error was detected by EEPROM check.
50 An error was detected by optional software ROM.
60 An error was detected by optional RAM check.
70 A fault occurred in the fan motor.
Controller
error
ERROR CONTROLLER
nn-aaaaaaaa
Light off Flash
Remedy
– Replace the program ROM.
(Location: BOARD-FFF: IC6, IC8, IC30, IC31)
– Replace the Main board (BOARD-FFF).
Note: When replacing the Main board, install the
EEPROM mounted on the replaced Main board.
– Replace the font ROM.
(Location: BOARD-FFF: IC6, IC8, IC30, IC31)
– Replace the Main board (BOARD-FFF).
Note: When replacing the Main board, install the
EEPROM mounted on the replaced Main board.
– Replace the Main board (BOARD-FFF).
Note: When replacing the Main board, install the
EEPROM mounted on the replaced Main board.
– Replace the EEPROM. (Location: IC19)
– Replace the Main board (BOARD-FFF).
– Replace the PostScript module (BOARD-MSM or
BOARD-FSL).
– Check the optional RAM for proper connection.
– Replace the optional RAM.
– Connect the fan motor cable properly.
– Replace the fan motor.
– Power Supply Unit (AC120V/ 230V)