Filter
Top Products
40930701TH DRAFT Vesion 93 /
Installing Duplex Unit
(1) Hold the LEVER-Lock (Dup) in horizontal lock position.
Then insert the Duplex Unit along the groove, up to accord both rear faces between printer
and Duplex Unit.
Note:
Printer and Duplex Unit will connect automatically with built-in connector.
(2) Lock the Duplex Unit to the printer by turning the LEVER-Lock (Dup) to the next locking
position as below.
(3) From front side of printer, snap fit LEVER-Release (Dup) into the boss in Hopping Frame.
(4) After installing Duplex Unit, put back the Paper Cassette into 1st Tray.
Groove
Connector
LEVER-Release (Dup)
Duplex Unit
Printer
Locking point
LEVER-Release (Dup)
LEVER-Lock (Dup)
Connector
Snap Fit Snap Fit
Snap Fit
into Boss
LEVER-Release (Dup)
Boss
LEVER-Release (Dup)
B
B
B - B View
Note:
Before setting it to the
unit, make sure that the
LEVER-Release (Dup) is
locked at the angle as
shown Locking point