Filter
Top Products
40930701TH DRAFT Vesion 234 /
4.3.2 Troubleshooting Flow
• ( JAM error )
Paper Input Jam
• Does paper jam at the inlet when the power is turned on?
• YES Is the paper located above the inlet sensor lever?
• YES Remove the paper.
▼
• NO Is the inlet sensor lever operating normally?
• NO Replace the inlet sensor lever.
▼
• YES Clean the inlet sensor 1 on the power supply unit (High Voltage) or
replace the power supply unit (High Voltage).
(See Figure 2.3 Sensor Layout Diagram)
▼
• NO When the paper is fed in, does the paper input jam occur?
• YES Is the paper being fed to above the inlet sensor lever?
• YES Is the inlet sensor lever operating normally?
• NO Replace the inlet sensor lever.
▼
• YES Clean the inlet sensor 1 on the power supply unit (High
Voltage) or replace the power supply unit (High Voltage).
(See Figure 2.3 Sensor Layout Diagram)
▼
• NO Replace the feed roller, roller-A or roller-B.
▼
• NO Are the feed roller, roller-A and roller-B rotating?
• YES Set the paper properly.
▼
• NO Is the belt torn?
• YES Replace belt.
▼
• NO Is the pulse motor turning?
• YES Replace planet gear.
▼
• NO Is the connector cable being connected properly?
• NO Connect the connector cable properly.
▼
• YES Check the coil resistance (approx. 32Ω) of the stepping motor.
Is it normal?
• NO Replace the stepping motor.
▼
• YES Replace the AOLE-PCB.