Filter
Top Products
Section 6 - Communication
Page 94 09/11/2008 REV 0.99
6.5.2.2 Remote Manager
The Remote Manager program is installed from the software installation disk that came with
the recorder. This program will run on a WAN (Wide Area Network) – over the Ethernet and
will work through a Firewall if the firewall is set up correctly. It will work over a LAN (Local
Area Network) but the Remote Display is more responsive as it uses multiple ports. Once
installed The Remote Manager is launched by double clicking the Remote Manager Icon
shown right. This launches the program window as shown below.
Select an IP Address from the pull down menu or add a new one by
clicking the ADD Recorder Icon – shown right. This will pop up a form
shown left to enter IP Address, Description and User name. Once this is
added click the ADD button to close.
Enter the password (which is never stored) and then press the
Connect Icon (right). If the user name and password is correct and the
recorder is accessible an image of the recorder screen will appear in
the window as shown below. If the program has to navigate the WAN it make take several
seconds to connect.
Fig 6.5.5 - Remote Manager Connected
You may control the recorder any way you wish. To terminate the connection hit the “X” in
the upper right corner or preferably the disconnect button in the control window(right).
You can zoom the display by pressing the Zoom Icon.
Fig 6.5.4 - Remote Manager