Filter
Top Products
Section 2 - Overview
Page 5 09/11/2008 REV 0.99
Figure 2-3 Media Door Contents
RESET
BUTTON
COMPACT
FLASH CARD
SOCKET
CARD EJECT
BUTTON
USB A
SOCKET
2.3.2 Media Door
The media door is opened by turning the key in the lock ¼ turn clockwise and pulling the door out and down.
Note that in order to meet the water resistance specification (IP65) the door must be closed and locked and
the waterproof lock cover must be snapped over the lock.
Opening the media door exposes the
compact flash card socket and the USB
port. The compact flash card is intended
as the principal recording media,
however the unit will record to a USB
device or to internal memory.
The compact flash card fits into the
socket as shown right. The card eject
button must fold over to the right once
the card is in place. To eject the card, lift
the eject button, press it to pop the card
out then fold it back over. Grab the card
along the left and right edges between
the thumb and forefinger and remove.
To the left of the card slot is a small
opening. Set back behind this opening is the system reset button. Under normal operation there should be no
need to use this. Using this button may cause loss of data.
2.3.3 Status Indicator
The status indicator is lit when the unit is powered on and blinks during shut down or when the unit is running
off the internal batteries. The internal batteries allow the unit to survive short power interruptions (< 15
seconds) or brown outs, during which time the display blanks and the status indicator blinks.
2.3.4 IR COMM Port
The IR COMM port is an Infrared send/receive port which allows connection to compatible Infrared devices.
Future Option.
2.3.5 Stylus
The stylus is used to do data entry on the touch screen. It is stored in the bottom right of the recorder front
panel. To remove it, depress the exposed top and turn ¼ turn counter clockwise. The stylus is sprung loaded
and will pop out of its docking location. CAUTION: Control removal of the stylus as it is spring loaded.
To return it to its docking location, insert the pointer end into the hole, fully depress it and give it a ¼ turn
clockwise.