Filter
Top Products
. . . . ..until the desired extension number appears
[08] [NEXT] (N:XT] [C...El [MEM,ORY][END]
;8] [NEXT] [ABI [C...E] [MEMORY][END]
to assign the same on all 16 extensions
Description Conditions
Through programming; you can select
of which
extensions may be used
for
outward dialing by
using the night mode
of
operation.
Programming
1. Dial (08).
n
“NIGHT: OUT CO” will be displayed,
2. Press the NEXT button.
“ENTER EXT NO.” will be displayed.
3. Press the NEXT button.
“11: CO 12 3 4 5 6” will be displayed
and “1
2 3 4 5 6” will blink.
4. Dial the CO numbers to be entered.
The desired combination
of
CO lines will be
displayed.
To prohibit dialing, press the CLEAR button
of
the CO number.
“11: CO.....” will be displayed.
5. Press the MEMO,RY button.
The LCD -will stop blinking.
6. Repeat steps 3 to 5, to program the assign-
ment on the other extensions.
: !
l
When you start the programming from step 1,
you may dial the desired extension number
instead
of
the NEXT button at step 3.
l
The PREV button allows you to go to the
previous
extension
for
displaying the CO
assignment.
Example: COMPANY XYZ
Company XYZ wants extensions 11, 13 and 16
to have access to CO 1, 2 and 3 on outgoing
calls during the night. Extensions 12, 14, 15, I7
and 18 are to be programmed
for access to only
CO 1 and 2.
1. [08]
[NEXT] [(NEXT) or (ll)] [l] [2] (31
[MEMORY]
2. [NEXT] [l] [2] [MEMORY]
3. [NEXT] [l] [2] [3] [MEMORY]
4. [NEXT] [l] [2] [MEMORY]
5. [NEXT] [l] [2] [MEMORY]
6. [NEXT] [l] [2] [3] [MEMORY]
7. [NEXT] [I] (2) [MEMORY]
8. [NEXT] [l] [2] [MEMORY]
[END]
Programming Table
See
page
6-15.
7. To return to the initial program mode, press
the END button.
3-16