Filter
Top Products
:----until the desired extension number appears
[14] [NEXT] [NEi(T] [SELkCT] [MEMORY] [END]
or
t
[l4] [NEXT] [AB] [SELECT] [MEMORY] [END]
7
‘AB=[%]:
to assign the same on all 16 extensions
Description
Conditions
Through programming, you can select of which
extensions may dial an Operator Call.
To deny all dialing that starts from “O”, set to
DISABLE.
Programming
1. Dial (14).
0 When you start the programming from step 1,
you may dial the desired extension number
instead
of
the NEXT button at step 3.
l
The PREV button allows you to go to the
previous extension
for
displaying the operator
call selection.
“OPERATOR CALL” will be displayed.
2. Press the NEXT button.
“ENTER EXT NO” will be displayed.
3. Press the NEXT button.
“11: ENABLE” will be displayed and
“ENABLE” will blink.
4. Press the SELECT button, to alternate be-
tween ENABLE and DISABLE to select the
desired mode.
5. Press the MEMORY button.
Tha LCD will stop blinking.
6. Repeat steps 3 to 5, to program the assign-
ment
of
the other extensions.
7. To return to the initial program mode, press
the END button.
3-23
*Operator call dialing can not be denied if
service class 1
of
Toll Restriction is used.
Example:
0 To prohibit operator call on extensiotl I2
[14] [NEXT] 1121 [SELECT] [MEMORY] IEND]
Programming Table
See page 6-l 6.