Filter
Top Products
32 C1572M (9/05)
INSTALLING OR REPLACING A CM9700-SER CARD
The CM9700-CC1 is shipped from the factory with a minimum of two CM9700-SER cards installed on the motherboard in ISA slots 1 and 2 (refer
to Figure 16). You can install additional CM9700-SER cards into ISA slots 3 and 4, totaling a maximum of four cards. You can also replace an
existing card. When installing or replacing a CM9700-SER card, you must set the interrupt and address jumpers on the new card.
Figure 16. CM9700-CC1 with Top Cover Removed
To install or replace a CM9700-SER card, do the following:
1. Power off the CM9700-CC1.
2. Remove the top cover of the CM9700-CC1 (refer to the Removing the CM9700-CC1 Top Cover section).
3. If replacing an existing CM9700-SER card, remove the card from the ISA slot.
4. On the new CM9700-SER card, set the W1 interrupt (IRQ) and W2 address select jumpers (refer to Figure 17 and to Table E). Note that the
jumper settings vary depending on the ISA slot into which the card is to be installed. If you are replacing a card, the jumper settings should
match the settings on the card being replaced.
WARNINGS:
• CM9700-SER card installation or replacement should be performed by qualified personnel only.
• Electrostatic discharge (ESD) precautions must be observed when installing or replacing a CM9700-SER card. Always wear a
grounding strap connected to an approved grounding source when working on or near exposed electronic equipment.
WARNING: Failure to power off the CM9700-CC1 can result in serious damage to the equipment.
CC1 CHASSIS, FRONT
CC1 CHASSIS, REAR
ISA SLOTS (DEFAULT
CM9700-SER CARDS SUPPLIED IN
ISA SLOTS 1 AND 2)
CM9700-SER CARD
ACCESS SLOTS (SLOT
COVERS REMOVED)