Filter
Top Products
192
Appendix NAVI/AV
Messages for Audio functions
When problems occur in the audio source, a message may appears on the display. Refer to the table
below to identify the problem, then take the suggested corrective action. If the error persists, contact
your dealer or your nearest PIONEER Service Center.
Built-in DVD drive
Hard disk drive (Music Library)
Message When What to do
Unreadable disc. If you try to use a disc which is incom-
patible with this system.
Insert a suitable disc.
If you insert a disc upside down. Insert the disc with the label upward.
If the disc is dirty. Clean the disc.
If the disc is cracked or otherwise dam-
aged.
Insert a normal, round disc.
Mechanical failure of DVD drive occur. Consult your Pioneer dealer.
Playback error.
Please remove the disc.
Electrical or mechanical error is occur. Press the RESET button. (“Hardware
manual” after reading page 175 in this
manual.)
Region code error The disc does not have the same region
number as the navigation system.
Replace the DVD-Video with one bearing
the correct region number.
Playback error due to irregu-
lar temperature. Please
remove the disc.
The temperature of built-in DVD drive is
out of the operating limits.
Park your vehicle to safe place, turn the
ignition switch off and wait until the
built-in DVD drive’s temperature returns
to within normal operating limits.
ATTENTION!
Viewing of front seat video
source while driving is strictly
prohibited.
Parking brake interlock is activated. Park your vehicle in the safe place and
apply the parking brake.
➲ Parking brake interlock ➞ Page 18
Search error If the title number, chapter number,
time, 10 key command, which you enter
in [10Key Search] are not exist. (This
message will appear when DVD drive
can not accept that command.)
Enter the available numbers or 10 key
command or use another search
method.
Message When What to do
This CD cannot be recorded If you insert a CD which prohibit second-
generation copies or duplicate.
Use another CD and retry.
• Recording error.
Switching to CD playback
mode
• Recording error.
Recording is stopped
• The recording was unsta-
ble. Restart the recording
from the beginning of the
track.
If recording can not be carried out with
skipping certain part of the disc continu-
ously because the disc is dirty,
scratched, otherwise damaged, the pick-
up lens of the DVD drive is dirty, or the
extreme vibration occur continuously.
• Clean the disc and retry.
• Clean the pick-up lens with a commer-
cially available cleaning kit for DVD, then
retry.
• Retry in vibration-free condition.
Exceeded playlist maxi-
mum. No more playlists can
be recorded.
If you try to record a new CD but the
playlists are maximum number. (The
album playlist can be stores up to 400.)
Delete some playlist and retry.
Playback error. Music
Library cannot be played
The music library component is abnor-
mal.
Consult your dealer.
MyMix cannot store more
than 99 tracks.
If you try to add the tracks but the MyMix
playlists are maximum number. (The
MyMix playlist can store the tracks up to
99.)
Delete some tracks and retry.