Filter
Top Products
94
Chapter 10Modifying the General Settings for Navigation Functions NAVI
❒ Depending on the cellular phones featur-
ing Bluetooth technology, signal strength
is not available.
(4) Installation Position
The installation position of the navigation sys-
tem is shown. That indicates whether the
installation position of the navigation system
is correct or not. If installed correctly, [OK]
appears. When the navigation system is
installed at an extreme angle exceeding the
limitation of the installing angle, [Incorrect
angle] will be displayed. When the angle of
the navigation system has been changed,
[Excessive vibration] will be displayed.
(5) Parking Brake
When the parking brake is applied, [On] is dis-
played. When the parking brake is released,
[Off] is displayed.
(6) Power Voltage
The power voltage (reference value) provided
from the vehicle battery to the navigation sys-
tem is shown. If the voltage goes out of the
range from 11 to 15V, check that power cable
connection is correct.
(7) Illumination
When the headlights or small lamps of a vehi-
cle are on, [On] is displayed. Small lamps of a
vehicle are off, [Off] is displayed. (If the
orange/ white lead is not connected, [Off]
appears.)
(8) Back Signal
When the gear lever is shifted to [R], the sig-
nal switches to [High] or [Low]. (Either of
these is displayed depending on the vehicle.)
Checking sensor learning status
and driving status
1 Touch [Settings] in the navigation menu,
then touch [Hardware].
2 Touch [3D Calibration Status].
The 3D Calibration Status screen appears.
(1) Distance
Driving distance is indicated.
(2) Speed Pulse
Total number of speed pulses is indicated.
(3) Learning Status
Current driving mode is indicated.
(4) Degree of learning
Sensor learning situations of distance (Dis-
tance), right turn (Right Turn), left turn (Left
Turn), and 3D detection (3D) are indicated by
the length of bars.
❒ When tires have been changed or chains
fitted, turning on the Speed Pulse allows
the system detects the fact that the tire
diameter has changed, and automatically
replaces the value for calculating distance.
❒ If the ND-PG1 is connected, the distance
calculation value cannot be replaced auto-
matically.
(5) Speed
Speed detected by the navigation system is
indicated. (This indication may be different
from the actual speed of your vehicle, so
please do not use this instead of the speedom-
eter of your vehicle.)
(6) Acceleration or deceleration/Rota-
tional speed
Acceleration or deceleration velocity of your
vehicle is indicated. Also, rotational speed
when your vehicle turns to left or right is
shown.
(7) Inclination
Degree of slope of the street is indicated.
(4)
(1)
(2)
(3)
(5)
(6)
(7)