Filter
Top Products
Introduction
1-3
EATON Powerware
®
9390 UPS (100–160 kVA) Installation and Operation Manual S 164201604 Rev B powerware.com
1.2 Using This Manual
This manual describes how to install and operate the Powerware 9390 UPS (100–160 kVA)
cabinet. Read and understand the procedures described in this manual to ensure
trouble-free installation and operation. In particular, be thoroughly familiar with the REPO
procedure (see page 10-7).
The information in this manual is divided into the sections and chapters listed. The system,
options, and accessories being installed dictate which parts of this manual should be read.
At a minimum, Chapters 1 through 3 and 8 through 10 should be examined.
Ī Chapter 1, “Introduction” – provides a brief description of the UPS system, a
description of the content of each chapter, text conventions used in the m anual, safety
warnings, and reference information.
Section I, Installation
Ī Chapter 2, “UPS Installation Plan and Unpacking” – explains how to prepare the site
for the installation of the UPS system. It discusses equipment environmental
requirements, inspecting, and unpacking cabinets.
Ī Chapter 3, “Installing the UPS System” – describes how to install and wire the UPS
cabinet and optional equipment.
Ī Chapter 4, “Batteries” – provides battery safety and installation information.
Ī Chapter 5, “Installing a Remote Emergency Power-off Control” – contains information
for installing the optional REPO control.
Ī Chapter 6, “Installing Options and Accessories” – contains information for installing an
X-Slot Powerware Hot Sync CAN Bridge Card, parallel control wiring, an RMP II, a Relay
Interface Module II (RIM II), or a Supervisory Contact Module II (SCM II).
Section II, Operation
Ī Chapter 7, “Understanding UPS Operation” – provides information on why and how a
UPS works.
Ī Chapter8,“Features,Options,andAccessories”–describes the standard and optional
UPS features and available accessories.
Ī Chapter 9, “Using the Control Panel” – describes the controls and indicators found on
the control panel and shows the various information screens displayed on the LCD.
Ī Chapter 10, “UPS Operating Instructions” – contains startup and shutdown procedures
for the UPS system.
Ī Chapter 11, “Using Features and Options” – contains descriptions and instructions for
the UPS system features and options.
Ī Chapter 12, “Responding to System Events” – listsallthealarmsandnoticesthatoccur
during operation of the UPS system.
Ī Chapter 13, “Communication” – describes the communication features of the UPS
system.