Filter
Top Products
Appendix B IR-IP Interface Module Installation and Operation Manual
B-14 Defining Management Access ASMi-52 Ver. 2.5
B.8 Defining Management Access
The Management Access menu is used to enable the use of passwords to protect
the access to IR-IP management utility, and control the inactivity time-out interval.
When password protection is enabled, a Telnet management session can start only
after the correct password is entered.
To access the Management Access menu:
• From the Main menu, type 2.
The Management Access menu appears (Figure B-8).
IR_IP <IR-IP> S/W Ver. 1.21 (date)
Quick Setup
Management Access
=====================================================================
1. Telnet Password :..........
2. Telnet Inactivity Timeout (min) :300..
3. SNMP Access :Disabled
4. SNMP Read Community :public....
5. SNMP Write Community :public....
6. SNMP Trap Community :public....
7. SNMP Management Table :>>>
Press one of the numbers to select or ESC:
Figure B-8. Management Access Menu
Since the IP router card does not support SNMP management, the SNMP Read
Community, SNMP Write Community, SNMP Trap Community, and SNMP
Management Table parameters are not used.
Defining a Telnet Password
By default, management access to IR-IP via Telnet is unrestricted. To restrict
access, enter a Telnet password by selecting 1 in the Management Access menu.
The password can include up to 10 characters, and is case-sensitive. The next time
a Telnet session is opened, a password must be entered to enable you to access
the IR-IP menus.
At any time, only one Telnet connection to IR-IP is permitted. Any attempt to
open an additional connection while the current session is open is rejected.
Setting Telnet Inactivity Timeout
This parameter specifies the time a Telnet session is kept open when there is no
keyboard activity. When the specified time-out expires, the Telnet session is closed
and another user can access IR-IP.
Note