Filter
Top Products
Installation and Operation Manual Appendix B IR-IP Interface Module
ASMi-52 Ver. 2.5 Advanced Setup B-17
Defining the WAN Protocol Parameters
Frame Relay Protocol
The Frame Relay Protocol Parameters menu is used to configure the parameters
Frame Relay WAN for protocol (the WAN protocol is selected by means of the
Quick Setup ) in Figure B-5.
To define the Frame Relay protocol parameters:
1. From the Advanced Setup menu, type 3. (A typical Frame Relay Protocol
Parameters menu is shown in Figure B-11.)
2. Specify the Self Learn for the Frame Relay DLCI and maintenance protocol
ENABLED = learned automatically
DISABLED = manually entered
3. If the Self Learn parameter is DISABLED, specify the Maintenance Protocol
4. If the Self Learn parameter is DISABLED, specify the DLCI used for exchanging
maintenance protocol messages.
5. Specify the CIR. This is the maximum amount of data, in bits, which the Frame
Relay network guarantees to transfer during the measurement interval (the
measurement interval is usually one second).
The value of this parameter is obtained from your Frame Relay service
provider.
6. Specify the EIR. This is the maximum amount of data, in bits, that the Frame
Relay network will attempt to deliver during the measurement interval. The
value of this parameter is obtained from the Frame Relay service provider.
IR_IP <IR-IP> S/W Ver. 1.21 (date)
Quick Setup
Management Access
Advanced Setup
.....................................................................
Device identification
Interface Parameters
Protocol Parameters
=====================================================================
1. Self Learn :[ Enabled ]
2. Maintenance Protocol :[ ANSI T1.617 ANNEX D ]
3. DLCI (0-None) :0..
4. CIR :0.......
5. EIR :64000...
Press one of the numbers to select or ESC:
Figure B-11. Frame Relay Protocol Parameters Menu