Filter
Top Products
Appendix C Easy Config Device Installation and Operation Manual
C-6 Operation ASMi-52 Ver. 2.5
7. Press the x button to select the value.
The s character designating space is stored in the bottom row:
s
111s
8. Repeat steps 4–7 to enter the remaining values. Mind the spaces between the
IP address portions.
The resulting display should look as follows:
s
111s222s33s44s
9. Press the ENTER button to complete the data entry.
10. Select Save from the Management menu.
Assigning Timeslots
The Easy Config offers an alternative method of the E1 or T1 timeslot assignment.
Instead of moving the cursor in the menu to every timeslot and assigning it to carry
data or idle code, it is possible to specify assigned timeslots directly.
To assign timeslots:
1. From the Time Slot Assignment menu (Configuration > E1 Configuration > E1
Local Port Configuration > Time Slot Assignment), select 34 CLEAR to
disconnect all timeslots.
2. Hold down the z button, and press the x button to initiate the alphanumeric
value enter mode.
3. Enter the numbers of the timeslots to be assigned to carry data, as explained in
the Entering Alphanumeric Values section above. The timeslot number must be
separated by spaces (character s).
The resulting display should look as follows:
s
11s12s13s14s
4. Press the ENTER button to complete the entry.
• Up to four timeslots can configured at a time.
• Timeslot 0 can be configured to the loop or transparent mode only via the
menu.
5. Save the changes.
Turning the Easy Config Off
To turn the Easy Config off:
• Set the top panel BAT switch to OFF and disconnect the AC/DC power
adapter from the mains.
Notes