Filter
Top Products
Chapter 3 Operation Installation and Operation Manual
3-6 Configuration Alternatives ASMi-52 Ver. 2.5
Parameter Default Value
Serial DTE Interface
Rate Single:
2-wire – 192 kbps
4-wire – 384 kbps
Multiplexer:
1. E1+Serial DTE, N/A, 0 kbps
2. LAN+Serial DTE: 2-wire – 192 kbps
4-wire – 384 kbps
LLB from DTE Disable
RLB from DTE Disable
E1/E1+Ethernet/E1+Serial DTE Interface
Framed mode Unframed
Sync CCITT
CRC-4 No
Idle Code ff
Units identical settings Yes
T1 Interface
Framed mode Unframed
Line code B8ZS
Receive gain Long
Interface DSU
Transmit signal mask 0 feet
Fbit configuration Transparent
Sync mode Fast (after 1 sec)
Idle code Ff
Units identical set Yes
3.4 Configuration Alternatives
After installation, ASMi-52 can be reconfigured using different ports and
applications:
• Local out-of-band management via an ASCII terminal or the Easy Config
device connected to the RS-232 port. Usually, preliminary configuration of the
system parameters is performed via an ASCII terminal. Once the ASMi-52 host
IP parameters are set, it is possible to access it via Telnet, ConfiguRAD, or
RADview-Lite for further configuration.